新闻动态
当前位置: 首页- 新闻中心 > 新闻动态 >

济南汽车贴膜贴完车窗膜后的注意事项

发布时间:2021-07-12 作者:济南量子膜专营店 文章来源:http://www.tiekemoshe.com/ 浏览量:

贴膜建议,在给爱车贴膜的时候,贴膜完成和检验完成后并不代表整个汽车贴膜装饰已经圆满,因为有很多的车主在贴完膜后都会返回来在继续修复,这时有人会问是不是膜的质量不好啊?还是贴膜的手艺不行?其实并不是这样的,问题不是出现在汽车贴膜技术上,而是在车膜过后对膜的保养没有做到位,因而严重影响汽车贴膜使用效果,严重的还需要重新去贴,那么汽车贴膜该注意哪些事项呢?
Film suggestion: when you apply film to your car, the completion of film application and inspection does not mean that the whole car film decoration has been completed, because many car owners will come back to continue to repair after film application. At this time, someone will ask if the quality of film is not good? Or is the technology of film not good? In fact, this is not the case. The problem is not in the technology of car film, but the maintenance of the film is not in place after the film, which seriously affects the use effect of car film. If it is serious, it needs to be pasted again. So what should we pay attention to?
汽车后窗图以下是关于注意事项:
The figure of rear window is as follows:
为确保贴膜后隔热膜与玻璃粘牢,一周内不能清洗隔热膜及开启除雾线开关。尽量不要让阳光直接暴晒玻璃,这将会引起起泡的后果,应该将车内空调打开让空气内外流通,靠着隔热膜本身的呼吸性形成自然固化,确保隔热膜安装后胶与玻璃完全结合,才能形成安全防爆作用。
In order to ensure that the heat insulation film is firmly adhered to the glass, the heat insulation film shall not be cleaned and the switch of demisting line shall not be turned on within one week. Try not to let the sun directly expose the glass, which will cause blistering. Turn on the air conditioner in the car to let the air circulate inside and outside. Rely on the breathability of the heat insulation film itself to form a natural curing, and ensure that the glue is completely combined with the glass after the heat insulation film is installed, so as to form a safe explosion-proof effect.
贴膜后,在汽车隔热膜与玻璃之间不可避免地会残留少许水分,可能会引起小气泡或轻微波痕,造成视线模糊,这是正常的。贴膜后,经太阳照射,4至10周之后会自然消失。若是在一段时间之后依然存在明显现象,注意不要擅自处理,应该找专业的技师进行处理。
After the film is applied, a little water will inevitably remain between the car heat insulation film and the glass, which may cause small bubbles or slight ripples, causing blurred vision, which is normal. After the film is applied, it will disappear naturally after 4 to 10 weeks of sunlight. If there is still an obvious phenomenon after a period of time, pay attention not to deal with it without authorization, you should find a professional technician to deal with it.
3.在清洗玻璃时,禁用酸碱性高的溶剂清洗,也尽量别让皮革油类的油性液体沾到汽车隔热膜上,清洗方式可以用清水或非酸碱性高的清洗液,市面上大多数玻璃清洗剂都能很好用来清洗隔热膜,更适合隔热膜的清洗液是水和家用清洁精以10比1的比例稀释而成。
3. When cleaning the glass, it is forbidden to use the solvent with high acidity and alkalinity, and try not to let the oily liquid of leather oil touch the car heat insulation film. The cleaning method can be water or non acidity and alkalinity high cleaning liquid. Most of the glass cleaning agents on the market can be used to clean the heat insulation film well, and the more suitable cleaning liquid for the heat insulation film is diluted by water and household cleaner in the ratio of 10:1.
4.隔热膜的表面硬化有限,为避免划刮伤汽车隔热膜,请勿使用刷子、砂纸等任何有硬颗粒的清洁用品,使用柔软布料或海绵清洗隔热膜表面才是正确的。清洗车身外的布料,也别拿来擦拭汽车隔热膜,因为使用在车身外的布料容易带有细沙,也是造成隔热膜刮伤的因素之一。
4. The surface hardening of the heat insulation film is limited. In order to avoid scratching the car heat insulation film, do not use brushes, sandpaper and other cleaning products with hard particles. It is correct to use soft cloth or sponge to clean the surface of the heat insulation film. Clean the cloth outside the car body, and don't use it to wipe the car insulation film, because the cloth used outside the car body is easy to carry fine sand, which is also one of the factors causing the scratch of the insulation film.
相关产品 MORE+
首页首页 产品产品 电话电话 置顶置顶