We all know that in addition to the quality of the film itself, the construction quality of the film accounts for the majority, so what are the processes of the car film? It is divided into several steps: cleaning, sticking the outer film, trimming, sticking the inner film, and trimming again.
First of all, spread two large bath towels on the front cover and instrument, cover the chair cover and wrap it tightly with plastic wrap. Clean every piece of glass completely and thoroughly, mainly taking care of the top of the glass.
Spray a small amount of window film installation liquid on the outer surface of the window glass, cover the soft mold on it, and cut it after careful sliding positioning. Make the film stick firmly to the glass during the shearing operation. Then cut the window film according to the mold. Apply the window film mounting solution to the glass, and then apply the film.
Because almost all of the window glass is not flat, so the use of baking gun can accurately shrink and shape the window film with most of the composite surface of the window.
Eliminate wrinkles on the surface. Next is the internal film, now the window film installation liquid spray evenly. After the film is applied, after each window film is settled in its final position, the installation liquid shall be sprayed on the surface of the window film again immediately to lubricate the water squeezed surface.
After that, the Yangtze River Delta plastic scraper is used to drive water, and the cotton cloth is used to suck out the water extruded from the edge of the window. It's done